Porcelain for Beginners—7 Tips for Getting Off to a Good Start with Porcelain
Switching to a porcelain clay body may seem like an easy enough thing to do, but if you’ve ever worked with porcelain, you know it is not as easy a switch as you might hope. That’s why we put together this post on porcelain for beginners!
In this article, an excerpt from Working With Porcelain, Antoinette Badenhorst, shares seven helpful tips for working with porcelain that will help beginners get off to a great start!
7 Tips on Working with Porcelain for Beginners
Sure porcelain can be a challenging clay body to work with, but by keeping some important tips in mind, you can have success when getting started with it. Here are some guidelines on porcelain for beginners that will help you along the way!
-
- Always wedge clay from a few hours to up to a day before using it to make sure that the water content is evenly distributed throughout the clay ball. This also helps to orient the clay particles into a circle or spiral. Although aged clay is stiff during the first few wedges, it’s much better than freshly made clay and it quickly softens. Allowing the porcelain to rest after its wedged is important, because it tends to fatigue easily.
- Pay special attention to centering and always cone the clay to get all the clay particles lined up. Many potters consider coning as just another way of wedging, but in many instances porcelain reminds me of the fairy tale of the princess that could not sleep with a pea under her mattress. The slightest little lump or unevenness can force you back to the beginning.
- Porcelain is normally thirsty, absorbing water quickly, and collapses easily when too much water is used. Even a more plastic porcelain clay body functions better with less water. Adding a spoonful of vinegar in the throwing water gently deflocculates the clay and helps in lubricating the clay. Since porcelain shrinks more than other clay bodies, using less water limits the problems related to shrinkage.
- Porcelain cracks easily for different reasons. If basic rules are important for working with other clay bodies, it becomes of the utmost importance to porcelain. Uneven thickness in clay walls and attaching pieces of uneven dryness will result in cracking. Cracks in the bottom of a form are usually caused by uneven thickness throughout and/or improper compression. Some cracks in the bottoms are caused by water left inside, which weakens the bottom. Cracks on rims are usually caused by too much pressure applied when trimming the foot. Using a foam bat on the wheel head while trimming absorbs the shock and eliminates most rim cracks. You can also prevent excessive pressure on fragile pieces by using sharp tools. Metal kidney ribs and Surform blades are some of my most important trimming tools.
- Fill a spray bottle with water and use it to keep the pieces damp as long as is needed while you’re working on them. Be careful as it takes some training of the hand and eye to prevent delamination of walls when spraying semi-dry pots to rehydrate them. Every porcelain body is different and needs to be evaluated separately, especially while drying.
- To be safe, never leave freshly thrown work in the open air longer than 15–30 minutes, no matter if you are working in Mississippi or Arizona.
- Here are two simple systems for keeping unfinished pieces leather hard for weeks while you work on them.
- Invert a lidded food container, set the pot on the inverted lid and place the container over top of it to seal the pots in while they are in process.
- Make a damp box by taking a plastic storage box, and pouring an inch or so of plaster into the bottom. After it cures, dampen the plaster slab and it will slowly release moisture into the air within the closed container.
